Results 1 to 10 of 11

Hybrid View

  1. #1
    The next big thing
    Join Date
    Oct 2012
    Location
    Bristol
    Posts
    223

    Default Joyo Voodoo Octave bypass

    Hi All,

    After seeing all the fuss about Joyo lately I decided to take the plunge and try them out. I bought the voodoo octave and it sounds pretty good - a nice musical fuzz and nasal octave. However, I've found the bypassed signal to be really obviously attenuated, with a lot less treble and generally duller sounding. I've never noticed tone suck anywhere near as bad as this with any other pedal - I like biting, treble heavy single coil sounds so it's a bit of a dealbreaker. Has anyone else had similar problems with the same pedal or other Joyo pedals?

  2. #2
    The ill-advised world music album
    Join Date
    Dec 2007
    Location
    the Thames Delta..
    Posts
    3,191

    Default

    not had anything like this with any of my joyo pedals (three on my board) - I did read somewhere there is a an octave mod as one of the capacitors was put in back to front but don't know what effect this had on the pedal.
    Don't let somebody elses world make yours unhappy...

  3. #3
    Rock royalty
    Join Date
    Sep 2010
    Location
    The Former British Republic Of Scotland
    Posts
    13,833

    Default

    Since the Joyo pedals are true bypass, either the bypass switch is faulty, or whatever comes after the Joyo is loading the signal heavily.
    "Just because I don't care doesn't mean I don't understand" - Homer Simpson

    http://www.facebook.com/TheAngelConversations

  4. #4
    The next big thing
    Join Date
    Oct 2012
    Location
    Bristol
    Posts
    223

    Default

    I have tried a/b'ing it with various pedals straight into the amp and the same problem is there so I don't think there is anything wrong with the signal chain. Maybe there is something up with the switch or the circuit then. I'll have a search for the capacitor mod.

  5. #5
    Rock royalty
    Join Date
    Sep 2010
    Location
    The Former British Republic Of Scotland
    Posts
    13,833

    Default

    Don't bother, it's the switch. The whole point of true bypass is that when the pedal is bypassed, the signal does not pass through any component in the effect circuit.

    It sounds like the switch is failing to disconnect either the circuit input or the output, which is then acting as a heavy load on the signal path.

    I'm going from memory here, but is the switch mounted on a PCB? If so it could be a trace printing error or a stray bit of soldering bridging the switch terminals.
    "Just because I don't care doesn't mean I don't understand" - Homer Simpson

    http://www.facebook.com/TheAngelConversations

  6. #6
    The next big thing
    Join Date
    Oct 2012
    Location
    Bristol
    Posts
    223

    Default

    I think you were right on the money there ICBM, the switch pcb looked a bit sloppy so I reflowed the solder for the contacts. The other possible cause was that the battery clip was in contact with the switch terminals and was rather wedged in. I've taped it out of the way now and it sounds much better in bypass. Now that weight is off my mind, I might check out the rest of the range...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •