Looking for some wiring advice.

[DanD1985]

Hi folks, looking to see if some wiser than I folks out there could advise me on a wiring job i'm trying.

I have a prs custom 24 with 5 way blade. Don't like the 5 way blade, much more a 3 way toggle switch user personally so in this case, I bought a 3 way blade switch.

I bought the schaller megaswitch T model from stew mac: http://www.stewmac.com/shop/Electron...h_T-Model.html

Now the diagram is pretty clear about connections when wirring like a tele as intended, but I would still like the ability to tap the coils of my p'ups and am using a push/push pot in the tone position.

Basically, the only bit i'm unsure of is what gets soldered to what on the push/push pot.

I'm aiming for the switch positions to be:

1-Bridge p'up
2-Bridge & Neck (series or parallel, I don't know which is ideal)
3-Neck p'up

Tapped
1-Bridge Tap
2-Neck & Bridge (again series or parallel, I don't know ideal setup)
3-Neck Tap

I presume that the 2 highest lugs farthest from the shaft are unused, the middle 2 are the p'ups split wires and the lowest 2 lugs (closest to shaft and front of guitar) are both wired to ground.

Is this correct?

If I try and draw the basic idea:

Topside pot
AB
CD
EF
Shaftside guitar front

AB would be unused, C would be neck split wire, D would be bridge split wire and EF would share common ground.

Is that correct or am I completely wrong?

Any and all help is very much appreciated!

Cheers,

Dan.

[DanD1985]

Still looking for advice if anyone is able to help.

Cheers,

Dan.

[ianpdq]

The center connections on the pickups switch to ground that will give you single coils

[DanD1985]

So you're saying the splits and ground connections should be the other way?

Cheers,

Dan.

[ecc83]

Still looking for advice if anyone is able to help.

Cheers,

Dan.

There is a top man, Zen, on geetars on the forum of www.soundonsound.com

Dave.

[DanD1985]

Cheers man, I'll head over there now.