Pedal debugging headache

[stickyfiddle]

Put together a pedalparts Stratoblaster clone last night. Plugged in- does it work? Does it fuck..

The switch is wired properly, and it passes a Teeny-tiny bit of signal when switched on but incredibly quiet. Anything obvious as to what might be wrong? The battery I'm using reads a healthy 8.6 so it's not that!

Schematic and layout can be found here:

http://pedalparts.co.uk/wp-content/u...12/blaster.pdf

[stickyfiddle]

Just spotted I have 2 resistors the wrong way round. That might be it..

[DaveMcK]

I'd be checking everything with a +/- (all the caps.) and that the Fet is in the right way.

Not sure about R6. What does CLR mean?

[stickyfiddle]

Current Limiting Resistor, ie the one attached to the LED.

The tranny and caps are definitely the right way round. This looks like a case of me misreading a couple of resistor codes

[thermionic]

Always good to double-check with a meter before you solder them in!