Electronics dudes - would this work?

[Nick.Botfield]

The master volume and tone work as normal. The third pot acts as a gradual split control for the bridge humbucker. Would it work or is there a flaw in my awesome plan?

[ianpdq]

Looks ok to me give it a go

[Sporky_McGuffin]

I believe that will work, and I think Washburn use it as the VCC. Not certain on that.

You might want to consider using a 1M pot so that the "unsplit" end is pretty close to unsplit. Or make it a no-load pot by cutting the conductive track at one end - make sure it's the correct end though!

[KrisUK]

As far as I'm aware, you can't have an "in-between".

It's either split or not.

[Foster]

I've done this before nick, i'm sure thats how i wired it up. Sounds great too!

[Nick.Botfield]

Thanks, all!

My £100 challenge is therefore going to have a gradual-split bridge humbucker and the following combinations:

Bridge
Bridge and middle
Middle
Bridge and neck
Neck

Bwar!

[mattbanshee]

As far as I'm aware, you can't have an "in-between".

It's either split or not.

Not true. You're just gradually bleeding one coil to ground.