Sport & Auto
- About Future
- Digital Future
- Cookies Policy
- Terms & Conditions
- Investor Relations
- Contact Future
Just looked on Evil bay and seen a Hong kong "epiphone" one for 25 squids........Anyone any dealings with these? are they legit? any good etc? I got one of those bolt on neck, spray it yourself saga jobbies and the harness that came with it has dental floss for wiring ! so want to upgrade without spending a fortune as its only for fun and to learn how the wiring goes
or of course if anyone has one going ???
is it just the wire thats bad ? or do the pots, caps and switch look better on the ebay harness ?
might just be worth getting a few feet of decent wire.
I've got some used CTS premium long/ split shaft (4 x 500K) pots if they are any good? They are pre-soldered for '50's LP' wiring and I could bung some caps on to them if required?
No worries if not but I'm not needing them and would happily do a good price for either just them alone or them wired up with some caps too. You might need to widen out your guitar's pot shaft holes to accommodate these larger pots though just to be upfront as well.
Try axetec they have good quality wiring kits for a very reasonable price.
Tokai LS70F With Mules
Epiphone Les Paul Modded
Shugz makes wiring kits and he is famous here as I noticed for their quality.
You need to push him a little bit more...
Had a look in the parts bag for other stuff last night and I also have a full Gibson Historic wiring kit as well (4 CTS-Gibson pots/ 2 bumblebee repro caps, all pre-wired ready to fit). Again, it's been used and removed from a Historic Gibson LP but that could also be quite suitable for the guitar in question here.
Like I said though, no worries at all if none of the above are suited Good luck with the project as well,